Videos uploaded by user “farmboy30117”
Tailgate Handle Replacement '88-98 Chevy Trucks
Tailgate handle & rods replacement on my '93 Chevy K1500
Views: 67880 farmboy30117
1993 Silverado K1500 Brake Master Cylinder Replacement
Replacing the brake master cylinder
Views: 72227 farmboy30117
Tractor Surging?  How to change the fuel filter
If your tractor is surging and you have enough fuel, then the fuel filter is about clogged. Most tractors use the CAV type filters and here is how they are replaced.
Views: 108024 farmboy30117
Ford New Holland Tractor Electric Fuel Shutoff
In this video, I try to explain how to diagnose and troubleshoot a malfunctioning electric fuel shutoff for a viewer. Hope you enjoy it!
Views: 13207 farmboy30117
1985 Chevy K10 Restoration Part 4
Getting everything ready to remove the cab. This is part 4 of a multi-part series on the restoration of my step-son's '85 K10. Thanks for watching!
Views: 4026 farmboy30117
1988-95 GM Truck Ignition Systems
A little about the type of ignition system in these trucks. A good video to watch is ScannerDanner at https://www.youtube.com/watch?v=_Ijhi7ai1HY&list=UUrf6f8hn5oy4alB2WXJCIqA
Views: 317387 farmboy30117
1993 Chevy Silverado Hard Starting Issues Resolved
A bad "new" relay was the issue. Thanks for all the ideas on where to look.
Views: 117240 farmboy30117
'93 Chevy Silverado EGR Solenoid Replacement
Check Engine trouble code 32. In this case it was a faulty solenoid valve.
Views: 199711 farmboy30117
Haynes vs. Chilton  Repair Manuals
My opinion of these two manuals. Neither one compares to a factory repair manual.
Views: 44896 farmboy30117
1974 Ford 3000 Diesel Old Start with Bad Battery
Trying to get the old 3000 cranked after sitting for months. Need a new battery.
Views: 9911 farmboy30117
1985 Chevy K10 Restoration Bed Work Part 12
Removing the right hand bedside and killing wasps. Thanks for watching and don't forget to subscribe to my other channel Farmboy's Garage.
Views: 3182 farmboy30117
Chevy 350 Engine Rebuild Part 3
Piston ring and piston installation. This is part 3 of a multi-part series of rebuilding this 350 engine. Stay tuned for part 4.
Views: 20911 farmboy30117
1985 Chevy K10 Restoration Part 1 - Bed Removal
In Part 1 we remove the bed using the wooden gantry we built. I sped certain sections up to make it more enjoyable to watch. "Hustle" Kevin MacLeod (incompetech.com) Licensed under Creative Commons: By Attribution 3.0 http://creativecommons.org/licenses/by/3.0/
Views: 16391 farmboy30117
Project Diesel Truck - Dash Pad Install
Installing a dash pad in my '83 Chevy K20
Views: 8187 farmboy30117
Kenmore Oasis HE Washer Repair - Part 2 - Rotor Position Sensor
Replacing the rotor position sensor on our Kenmore washer
Views: 26433 farmboy30117
1993 Chevy Silverado Hard Starting Issues Part 1
My chevy truck will not fire right up like it used to. I suspect fuel pump relay issues.
Views: 95822 farmboy30117
1985 Chevy K10 Restoration Part 22
Installing the clutch. Thanks for watching!
Views: 1913 farmboy30117
'85 Chevy C30 Rear Hub Seal Repair  - Part 1
Repairing a leaky hub seal - Part 1 - hub removal
Views: 19862 farmboy30117
Tractor's generator not charging? Try this...
If you have an older tractor with a generator instead of an alternator and the battery is disconnected or dies, then the generator won't put out any voltage. Try this before replacing the voltage regulator.
Views: 95047 farmboy30117
NP208 Transfer Case Reassembly Part 6
In part 6, I disassemble the main shaft components. Thanks for watching!
Views: 2967 farmboy30117
Installing ball joints on GM 10-bolt
Installing the ball joints in my '83 Chevy K20 with the 10 bolt front end
Views: 13738 farmboy30117
1985 Chevy K10 Restoration Part 10 - frame prep
Prepping the frame and first coat of POR15. This is part 10 of a multi-part series on the restoration of my step-son's K10. Thanks for watching! "Hustle" Kevin MacLeod (incompetech.com) Licensed under Creative Commons: By Attribution 3.0 http://creativecommons.org/licenses/by/3.0/
Views: 4103 farmboy30117
Chevy 350 Engine Rebuild Part 8
Harmonic Balancer and Water Pump Install. This is part 8 of a multi-part series on rebuilding this engine. Thanks for watching!
Views: 24632 farmboy30117
Wiper Repair on '88-'98 Chevy Trucks
Replacing the wiper control board fixed the issues I was having with my wipers.
Views: 194555 farmboy30117
Baler repair part 8
What I've been doing this week on the baler
Views: 3941 farmboy30117
Baler Repair Part 7
More painting...
Views: 3962 farmboy30117
Grille Replacement '88-98 Chevy trucks
Replacing front grille on my '93 K1500. This procedure is basically the same on all 1988 to 1998 chevy trucks.
Views: 130185 farmboy30117
baler repair part1
Starting to tear down my New Holland 268. Got the plunger out...stay tuned for more!
Views: 13686 farmboy30117
1993 Chevy Silverado Radiator Replacement
Replacing a bad radiator on my '93 Silverado.
Views: 24528 farmboy30117
Baler Repair Part 14 - Plunger
Repairing the plunger on my New Holland 268 baler
Views: 15719 farmboy30117
Case 230 Baler - Running the twine
How to run the twine from the twine box to the needles on a Case 230 baler. Most small square balers are similar.
Views: 10940 farmboy30117
Fluffing 1st Hay Cutting 2013
Using the Kuhn tedder to spread the hay I cut yesterday. Thanks for watching!
Views: 15231 farmboy30117
Home Grown Beef - Wrap-up
Last video in this series. I show you how I wrap meat with the 18" freezer paper.
Views: 9993 farmboy30117
Mustang 930A Oil Change
Changing the oil in my skidsteer for the first time in over 3 years! I know...I'm a bad owner!
Views: 3557 farmboy30117
1974 Ford 3000 Battery Replacement
In this video, I replace a 5 year old 4DLT battery with a new one and flash the field on the generator. I also show where the oil pressure sending unit is located. Thanks for watching!
Views: 7249 farmboy30117
Tagged! 30 Facts about Farmboy30117
Got Tagged by Calvin's Corner72 to do a 30 fact video on myself so y'all can get to know me better. Thanks Calvin! https://www.youtube.com/watch?v=59wu7GHOA4I Tagged: Mossman381, Steve Rob, Wyattoneable, SMA, & Bubba's Garage!
Views: 904 farmboy30117
1985 Chevy C30 Replacing Accumulator and Flushing System
A/C Repair - I'm replacing the accumulator and flushing the evaporator core in preparation of hooking up hoses from compressor and pulling a vacuum. I added about 4 oz Ester oil to accumulator, the other 4 oz will be added to suction side of compressor. Next video will be hooking up the compressor.
Views: 35952 farmboy30117
Chevy 350 Engine Rebuild Part 1
Looking at what parts I'm putting in it and washing the block. This will be a comprehensive series detailing the entire engine rebuild process.
Views: 33670 farmboy30117
Craftsman YS4500 Deck Removal
Removing the deck to replace the blades on my 2006 Craftsman lawn mower.
Views: 13999 farmboy30117
Repairing mower and cutting hay
I fixed one problem and then had another....
Views: 8932 farmboy30117
New Holland 3930 Walk-Around
by request from farmlife312
Views: 5018 farmboy30117
GM Hydroboost Brake Lines
Quick vid for a viewer request on the GM Hydroboost brake system hoses.
Views: 2177 farmboy30117
NH 3930 Muffler Replacement
Replacing the muffler on our '94 New Holland 3930. Thanks for watching!
Views: 2619 farmboy30117
1993 Silverado A/C Pressure Switch Connector Replacement
Showing how to replace the wiring connector for the A/C pressure switch. Thanks for watching!
Views: 35193 farmboy30117
'93 Chevy Silverado Cylinder Head Removal & Inspection
Trying to find out what happened to my 350 engine. Blown head gasket was suspected.
Views: 14295 farmboy30117
Is my hay dry enough?
How to tell if your hay is ready to bale
Views: 49967 farmboy30117
'73-87 Chevy Truck Gauge Cluster Repair
Replacing the circuit board on the gauge cluster. Pretty easy, straightforward job. Thanks for watching!
Views: 30886 farmboy30117
Nilight 20" LED Light Bar Review
Installing a 20" Nilight LED Light Bar on my 2016 Jeep Wrangler. This is a very nice light bar. It is IP67 waterproof and has great heat dissipation. If you're planning to buy one, use the code below! Nilight 20" Light Bar: http://amzn.to/2cWpEFD  $2 off discount code for ordering this light bar: NilightA  ( Sold by: Nilight Online Shop) www.nilight.com
Views: 35292 farmboy30117
1985 Chevy K10 Restoration Part 118
Sanding and buffing more on the hood. Still have a lot of sanding scratches to get out. Thanks for watching!
Views: 494 farmboy30117
First Cutting with the Rebuilt Kuhn GMD 500 Mower
Mower turned out good. Thanks for watching!
Views: 7925 farmboy30117